Armstrong Hardwood & Laminate Cleaning System

Product ID: 5780

Availability: Typically Ships In 5 to 7 Business Days
Manufacturer: Armstrong
Category: Care / Maintenance
 
Hardwood and Laminate Cleaner S-302
Prepared 06/09
 
Armstrong World Industries, Inc.
P.O. Box 3001
Lancaster, PA 17604
Technical Services:
1-877-276-7876, Option 2,3,3
 
MATERIAL DATA SAFETY SHEET
 
I.  Product Identification
Name:  Armstrong Hardwood and Laminate Cleaner, S-302
Description:  Alcohol based, floor cleaner
 
II.  DEPARTMENT OF TRANSPORTATION INFORMATION
Shipping name:  not classified.
Hazard Class:  N/A.
ID#:  N/A
Packing Inst.:  N/A
DOT/IMO/IATA:  N/A
EMERGENCY ONLY CONTACT:  CHEM-TEL 1-800-255-3924
 
III.  HMIS (0=minimal hazard; 4=severe hazard)
Health = 1
Flammability = 1
Reactivity = 0
 
IV.  PRODUCT CONTENT
This product contains ethylene glycol monobutyl ether which is subject to the reporting requirements of Section 313 SARA Title III and 40 CFR 372.  All components are on TSCA Inventory.  This product does NOT contain asbestos.
 
V.  HAZARDOUS INGREDIENTS

Chemical Identity; Common Name

C.A.S. No.

%

OSHA PEL

ACGIH TLV

Isopropyl Alcohol

67-63-0

6 - 9

400 ppm

400 ppm
 

Ethylene Glycol Monobutyl Ether

111-76-2

1

50 ppm

20 ppm
 
 
VI.  PHYSICAL DATA
APPEARANCE AND COLOR:  Blue opaque liquid.  ODOR:  Lemon odor.  BOILING RANGE (degrees F):  N/K.  VAPOR PRESSURE:  Like water.   VAPOR DENSITY:  Heavier than air.  SOLUBILITY IN WATER:  Soluble in water.  SPECIFIC GRAVITY:  1.0.  PERCENT VOLATILE BY WEIGHT:  8%.  EVAPORATION RATE:  Similar to water.  pH:  Neutral.
 
VII.  FIRE AND EXPLOSION HAZARD DATA
FLASH POINT (Method):  187° F.  FLAMMABILITY RANGE:  1 - 10%.  AUTOIGNITION TEMPERATURE:  N/A.  EXTINGUISHING MEDIA:  Foam, carbon dioxide or dry chemical.    SPECIAL FIRE FIGHTING PROCEDURES:  Protect fire fighters from breathing toxic products of combustion by wearing self-contained breathing apparatus.  UNUSUAL FIRE AND EXPLOSION HAZARDS:  Vapors are heavier than air and may travel along the ground or be moved by ventilation and be ignited by heat, pilot lights, or other sources of ignition at locations distant from the material handling point.
 
VIII.  HEALTH HAZARD DATA
PRIMARY ROUTE(S) OF ENTRY:  Skin contact, eye contact, inhalation.    EYE CONTACT:  Will cause irritation to eyes.  SKIN CONTACT:  Will cause irritation to skin, prolonged or repeated contact can cause moderate irritation if not promptly washed from skin.  INHALATION:  Inhalation of vapor may cause headache, nausea, irritation of nose, throat and lungs.  CARCINOGENICITY:  NTP:  No.  IARC Monographs:  No.  OSHA Regulated:  No.  FIRST AID PROCEDURES:  EYES:  Upon eye contact, flush eyes with plenty of water for at least 15 minutes.  If irritation persists, seek medical attention.  SKIN:  Upon skin contact,  wash affected area with soap and water.  Get medical attention if symptoms persist.  INHALATION:  Remove to fresh air.  Refer to physician if irritation or symptoms persist.  INGESTION:  Do not induce vomiting, call a physician immediately.
 
IX.  REACTIVITY DATA
STABILITY:  Stable under normal storage conditions.  INCOMPATIBILITY:  Strong oxidizing agents or mineral acids.  HAZARDOUS DECOMPOSITION PRODUCTS:  Carbon monoxide, carbon dioxide.  HAZARDOUS POLYMERIZATION:  Will not occur under normal conditions.
 
X.  SPILL OR LEAK PROCEDURES
SPILLS:  Remove sources of ignition.  Contain spill.  Wear appropriate protective equipment during clean-up and ventilate area.  Absorb with an inert material, such as clay and remove to appropriate waste area.  Floor may become slippery.  WASTE DISPOSAL METHOD:  Dispose of container and any unused contents in accordance with Federal, State and Local Waste Disposal Regulations.  Do not flush unused contents or residue down drains.  Do not reuse container.
 
XI.  SPECIAL HANDLING AND USE INFORMATION
VENTILATION:  Use with adequate ventilation.  Use local exhaust to insure that vapor levels are below the lowest component TLV.  RESPIRATORY PROTECTION:  Not normally needed, if there is not adequate ventilation, use with a NIOSH approved vapor cartridge respirator.  SKIN AND EYE PROTECTION:  It is always a good safety practice to avoid contact with eyes and prolonged contact with skin.  If contact may occur, use chemical splash goggles and latex or rubber gloves.
 
XII.  SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE:  Do not store in excessive heat.  Keep away from heat and flame.  Keep container closed when not in use.  KEEP OUT OF REACH OF CHILDREN.   OTHER PRECAUTIONS:  None.  WORK SITE ENVIRONMENT:  Initially there may be a potential adverse impact on indoor air quality within the general work area during the installation process.  Therefore you should advise the building manager or other appropriate person that: 
  • It will be necessary to establish and maintain adequate ventilation of the work area, without causing the entry of contaminants to other parts of building; and
  • Persons who are sensitive to odors and/or chemicals should be advised to avoid the work area during this process.
The information presented herein is supplied as a guide to those who handle or use this product.  Safe work practices must be employed when working with any materials.  It is important that the end user makes a determination regarding the adequacy of the safety procedures employed during the use of this product.
 
N/A - not applicable or not available
N/K - none known or not known