Hardwood and Laminate Cleaner S-302
Prepared 06/09
Armstrong World Industries, Inc.
P.O. Box 3001
Lancaster, PA 17604
Technical Services:
1-877-276-7876, Option 2,3,3
MATERIAL DATA SAFETY SHEET
I. Product Identification
Name: Armstrong Hardwood and
Laminate Cleaner, S-302
Description: Alcohol based,
floor cleaner
II. DEPARTMENT OF TRANSPORTATION
INFORMATION
Shipping name: not classified.
Hazard Class: N/A.
ID#: N/A
Packing Inst.: N/A
DOT/IMO/IATA: N/A
EMERGENCY ONLY CONTACT: CHEM-TEL
1-800-255-3924
III. HMIS (0=minimal
hazard; 4=severe hazard)
Health = 1
Flammability = 1
Reactivity = 0
IV. PRODUCT CONTENT
This product contains ethylene glycol
monobutyl ether which is subject to the reporting requirements of
Section 313 SARA Title III and 40 CFR 372. All components are on TSCA Inventory.
This product does NOT contain asbestos.
V. HAZARDOUS INGREDIENTS
|
Chemical Identity; Common Name
|
C.A.S. No.
|
%
|
OSHA PEL
|
ACGIH TLV
|
|
Isopropyl Alcohol
|
67-63-0
|
6 - 9
|
400 ppm
|
400 ppm
|
|
|
|
|
|
|
|
Ethylene Glycol Monobutyl Ether
|
111-76-2
|
1
|
50 ppm
|
20 ppm
|
VI. PHYSICAL DATA
APPEARANCE AND COLOR: Blue
opaque liquid. ODOR: Lemon odor. BOILING RANGE
(degrees F): N/K. VAPOR PRESSURE: Like water. VAPOR
DENSITY: Heavier than air. SOLUBILITY IN WATER: Soluble in water.
SPECIFIC GRAVITY: 1.0. PERCENT VOLATILE BY WEIGHT: 8%. EVAPORATION
RATE: Similar to water. pH: Neutral.
VII. FIRE AND EXPLOSION
HAZARD DATA
FLASH POINT (Method): 187° F.
FLAMMABILITY RANGE: 1 - 10%. AUTOIGNITION TEMPERATURE: N/A.
EXTINGUISHING MEDIA: Foam, carbon dioxide or dry chemical.
SPECIAL FIRE FIGHTING PROCEDURES: Protect fire fighters from breathing toxic
products of combustion by wearing self-contained breathing apparatus. UNUSUAL
FIRE AND EXPLOSION HAZARDS: Vapors are heavier than air and may travel along
the ground or be moved by ventilation and be ignited by heat, pilot lights, or other
sources of ignition at locations distant from the material handling point.
VIII. HEALTH HAZARD
DATA
PRIMARY ROUTE(S) OF ENTRY: Skin
contact, eye contact, inhalation. EYE CONTACT: Will cause
irritation to eyes. SKIN CONTACT: Will cause irritation to skin, prolonged
or repeated contact can cause moderate irritation if not promptly washed from skin.
INHALATION: Inhalation of vapor may cause headache, nausea, irritation of
nose, throat and lungs. CARCINOGENICITY: NTP: No. IARC Monographs:
No. OSHA Regulated: No. FIRST AID PROCEDURES: EYES: Upon eye contact, flush
eyes with plenty of water for at least 15 minutes. If irritation
persists, seek medical attention. SKIN: Upon skin contact, wash
affected area with soap and water. Get medical attention if symptoms persist.
INHALATION: Remove to fresh air. Refer to physician if irritation or
symptoms persist. INGESTION: Do not induce vomiting, call a physician
immediately.
IX. REACTIVITY DATA
STABILITY: Stable under normal
storage conditions. INCOMPATIBILITY: Strong oxidizing agents or mineral
acids. HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon
dioxide. HAZARDOUS POLYMERIZATION: Will not occur under normal conditions.
X. SPILL OR LEAK PROCEDURES
SPILLS: Remove sources of ignition.
Contain spill. Wear appropriate protective equipment during clean-up and ventilate
area. Absorb with an inert material, such as clay and remove to appropriate
waste area. Floor may become slippery. WASTE DISPOSAL METHOD:
Dispose of container and any unused contents in accordance with Federal, State and
Local Waste Disposal Regulations. Do not flush unused contents or residue
down drains. Do not reuse container.
XI. SPECIAL HANDLING
AND USE INFORMATION
VENTILATION: Use with adequate
ventilation. Use local exhaust to insure that vapor levels are below the lowest
component TLV. RESPIRATORY PROTECTION: Not normally needed, if there
is not adequate ventilation, use with a NIOSH approved vapor cartridge respirator.
SKIN AND EYE PROTECTION: It is always a good safety practice to avoid contact
with eyes and prolonged contact with skin. If contact may occur, use
chemical splash goggles and latex or rubber gloves.
XII. SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING
AND STORAGE: Do not store in excessive heat. Keep away from
heat and flame. Keep container closed when not in use. KEEP OUT OF REACH
OF CHILDREN. OTHER PRECAUTIONS: None. WORK SITE ENVIRONMENT:
Initially there may be a potential adverse impact on indoor air quality within the
general work area during the installation process. Therefore you should advise
the building manager or other appropriate person that:
-
It will be necessary to establish
and maintain adequate ventilation of the work area, without causing the entry of
contaminants to other parts of building; and
-
Persons who are sensitive to odors
and/or chemicals should be advised to avoid the work area during this process.
The information presented herein is
supplied as a guide to those who handle or use this product. Safe work practices
must be employed when working with any materials. It is important that the
end user makes a determination regarding the adequacy of the safety procedures employed
during the use of this product.
N/A - not applicable or not available
N/K - none known or not known