S-795
Prepared 06/09
Armstrong World Industries, Inc.
P.O. Box 3001
Lancaster, PA 17604
Technical Services:
1-877-276-7876, Option 2,3,3
MATERIAL DATA SAFETY SHEET
I. Product Identification
Name: Armstrong S-795 Genuine Linoleum Floor Stripper
Description: Wax stripper
II. DEPARTMENT OF TRANSPORTATION INFORMATION
Shipping name: Not classified.
Hazard Class: N/A.
ID#: N/A
EMERGENCY ONLY CONTACT: CHEM-TEL 1-800-255-3924
III. HMIS (0=minimal hazard; 4=severe hazard)
Health = 1
Flammability = 0
Reactivity = 0
IV. PRODUCT CONTENT
This product contains chemicals subject to the reporting requirements of Section 313 SARA Title III and 40 CFR 372. All components are on TSCA Inventory.
V. HAZARDOUS INGREDIENTS
|
Chemical Identity; Common Name |
C.A.S. No. |
% |
OSHA PEL |
ACGIH TLV |
|
Dipropylene Glycol Methyl Ether |
34590-94-8 |
5 |
100 ppm |
100 ppm |
|
|
|
|
STEL: 150 ppm |
STEL: 150 ppm |
|
|
|
(Skin) |
(Skin) |
|
|
|
|
As ammonia: |
|
|
Aqua Ammonia |
1336-21-6 |
<5 |
50 ppm |
25 ppm |
|
|
|
STEL: 35 ppm |
STEL: 35 ppm |
VI. PHYSICAL DATA
APPEARANCE AND COLOR: Water clear liquid. ODOR: N/A. VAPOR PRESSURE (mm Hg @ 20 degrees C): N/K. VAPOR DENSITY (Air = 1): N/K. PERCENT VOLATILE BY WEIGHT (30 min. @ 275 degrees F): 90. EVAPORATION RATE (Butyl Acetate = 1): N/K. SOLUBILITY IN WATER: Soluble. SPECIFIC GRAVITY (H²O = 1): 1.01. pH: 10.75 or less.
VII. FIRE AND EXPLOSION HAZARD DATA
FLASH POINT (MEHTOD): None to 230° F (110° C). FLAMMABLE RANGE: LEL = N/A. UEL = N/A. EXTINGUISHING MEDIA: Water, Dry Chemical, CO2, Water Fog. SPECIAL FIRE FIGHTING PROCEDURES: N/A. UNUSUAL FIRE AND EXPLOSION HAZARDS: None.
VIII. HEALTH HAZARD DATA
PRIMARY ROUTE(S) OF ENTRY: Skin and eyes. TARGET ORGANS: Skin and eyes. EFFECTS OF OVEREXPOSURE: SKIN AND EYES: Contact with eyes will cause severe irritation. Prolonged contact with skin of undiluted product may cause slight irritation. INHALATION: Normal end-product use does not present an inhalation hazard. CARCINOGENICITY: NTP: No. IARC Monographs: No. OSHA Regulated: No. MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Existing skin conditions. FIRST AID PROCEDURES: SKIN AND EYES: If product gets in eyes, flush with water continuously for at least 15 minutes. If wearing contact lenses, they must be removed immediately and flushing continued. Consult a physician. For skin contact, flush well with water. Refer to physician if irritation or symptoms persist. If spilled on clothing, remove and launder before wearing again. INHALATION: None required. INGESTION: Call a physician or Poison Control Center.
IX. REACTIVITY DATA
STABILITY: Stable. INCOMPATIBILITY: Do not mix with chlorinated products. High temperatures. HAZARDOUS DECOMPOSITION PRODUCTS: Normal products of combustion. HAZARDOUS POLYMERIZATION: Will not occur.
X. SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Wear eye protection and rubber or latex gloves to avoid eye and skin contact. Mop up, or otherwise pick up product with absorbing materials. Rinse area with clean, cold water; then dry. WASTE DISPOSAL METHOD: Do not reuse container. Dispose of container and any unused contents in accordance with Federal, State and Local Waste Disposal Regulations. Do not flush unused contents or residue down drains.
XI. SPECIAL HANDLING AND USE INFORMATION
VENTILATION: Normal ambient air circulation or ventilation should be adequate. RESPIRATORY PROTECTION: Should not be required. SKIN AND EYE PROTECTION: Avoid contact with eyes and skin. Spectacle-type glasses and latex or rubber gloves are recommended to avoid contact. Contaminated clothing should be immediately removed and not reworn until laundered. While on bended knees, do not kneel in product or solution of product.
XII. SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Keep out of reach of children. Keep from freezing. OTHER PRECAUTIONS: Avoid eye contact and prolonged skin contact with the product after dilution.
The information presented herein is supplied as a guide to those who handle or use this product. Safe work practices must be employed when working with any materials. It is important that the end user makes a determination regarding the adequacy of the safety procedures employed during the use of this product.
N/A - not applicable or not available
N/K - none known or not known